Repair procedures

Inspection Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replac ...

Components and Components Location

Component Location 1. Horn switch 2. Horn relay (Engine room compartment) 3. Horn 4. Clock spring ...

See also:

Mode selection
Type A The mode selection button controls the direction of the air flow through the ventilation system. The air flow outlet port is converted as follows: Refer to the illustration in the “M ...

ETC (Electronic Throttle Control) System. Specifications
Specification [Throttle Position Sensor (TPS)] Throttle Angle(°) Output Voltage(V) TPS1 TPS2 0 0.0 5.0 ...

MTS Antenna. Repair procedures
Removal Roof Antenna (GPS) 1. Remove the rear roof trim. (Refer to the BD group - "Roof trim") 2. Disconnect the GPS (A) ...