Hyundai Sonata: Specifications - General Information - Emission Control SystemHyundai Sonata: Specifications

Specifications

Purge Control Solenoid Valve (PCSV)
▷ Specification
Item
Specification
Coil Resistance (Ω)
19.0 ~ 22.0 [20°C(68°F)]

Fuel Tank Pressure Sensor (FTPS)
▷ Type: Piezo-Resistive Pressure Sensor
▷ Specification
Pressure
[kPa (kgf/cm², in H2O)]
Output Voltage (V)
-6.67 (-0.068, -26.8)
0.5
0
2.5
+6.67 (0.068, 26.8)
4.5

Canister Close Valve (CCV)
▷ Specification
Item
Specification
Coil Resistance (Ω)
19.9 ~ 22.9 [20°C(68°F)]


Tightening Torques

Item
kgf.m
N.m
lb-ft
Positive crankcase ventilation valve installation
0.19 ~ 0.29
1.9 ~ 2.8
1.4 ~ 2.1
Canister installation bolt
0.4 ~ 0.6
3.9 ~ 5.9
2.9 ~ 4.3


    Description and Operation
    Description Emissions Control System consists of three major systems. • The Crankcase Emission Control System prevents blow-by gas from releasing into the atmosphere. T ...

    Troubleshooting
    Troubleshooting Symptom Suspect area Engine will not start or struggle to start Vapor hose damaged or disconnected Engine strugg ...

    See also:

    To resume cruising speed at more than approximately 25 mph (40 km/h)
    If any method other than the cruise ON/OFF switch was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when the RES+ switch ...

    Crankshaft Position Sensor (CKPS). Description and Operation
    Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the If there is no CKPS signal input, the engine may stop because of ...

    Fuel Tank. Repair procedures
    Removal 1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 2. Remove the ...