Hyundai Sonata: Vehicle break-in process - IntroductionHyundai Sonata: Vehicle break-in process

No special break-in period is needed. By following a few simple precautions for the first 600 miles (1,000 km) you may add to the performance, economy and life of your vehicle.

  • Do not race the engine.
  • While driving, keep your engine speed (rpm, or revolutions per minute) between 2,000 rpm and 4,000 rpm.
  • Do not maintain a single speed for long periods of time, either fast or slow. Varying engine speed is needed to properly break-in the engine.
  • Avoid hard stops, except in emergencies, to allow the brakes to seat properly.
  • Don't let the engine idle longer than 3 minutes at one time.
  • Don't tow a trailer during the first 1,200 miles (2,000 km) of operation.

CALIFORNIA PROPOSITION 65 WARNING

Items contained in motor vehicles or emitted from them are known to the State of California to cause cancer and birth defects or reproductive harm. These include:

  • Gasoline and its vapors
  • Engine exhaust
  • Used engine oil
  • Interior passenger compartment components and materials
  • Component parts which are subject to heat and wear

In addition, battery posts, terminals and related accessories contain lead, lead compounds and other chemicals known to the State of California to cause cancer and reproductive harm.

    Operation in foreign countries
    If you are going to drive your vehicle in another country, be sure to: Observe all regulations regarding registration and insurance. Determine that acceptable fuel is available. ...

    Vehicle data collection and event data recorders
    This vehicle is equipped with an event data recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road ...

    See also:

    Inhibiter Switch. Description and Operation
    Description Item Specification Type Combination of output signals from 4 terminals  Power supply 12V ...

    Wheel replacement
    When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset. WARNING A wheel that is not the correct siz ...

    Repair procedures
    General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below ...