Hyundai Sonata: Air intake control

Type A

Type B
This is used to select the outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button.
Recirculated air position

With the recirculated air position selected, air from the passenger compartment will be drawn through the heating system and heated or cooled according to the function selected.
Outside (fresh) air position

Type A

Type B
With the outside (fresh) air position selected, air enters the vehicle from outside and is heated or cooled according to the function selected.
✽ NOTICE
Prolonged operation of the heater in the recirculated air position (without air conditioning selected) may cause fogging of the windshield and side windows and the air within the passenger compartment may become stale. In addition, prolonged use of the air conditioning with the recirculated air position selected will result in excessively dry air in the passenger compartment.
WARNING
- Continued use of the climate control system operation in the recirculated air position may allow humidity to increase inside the vehicle which may fog the glass and obscure visibility.
- Do not sleep in a vehicle with the air conditioning or heating system on. It may cause serious harm or death due to a drop in the oxygen level and/or body temperature.
- Continued use of the climate control system operation in the recirculated air position can cause drowsiness or sleepiness, and loss of vehicle control. Set the air intake control to the outside (fresh) air position as much as possible while driving.
Air intake control
Type A
Type B
Adjusting the driver and passenger side temperature individually
1. Press the DUAL button to operate the driver and passenger side temperature
individually. Turning the righ ...
Fan speed control
The fan speed can be set to the desired speed by pushing the fan speed control
button.
To change the fan speed, press the right of the button ()
for higher speed, or press the left of the butto ...
See also:
Engine Control Module (ECM). Repair procedures
Removal
When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
...
Body Repair
Interior A
Interior B
Interior C
Interior D
...
Anchor Pretensioner (APT). Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Using a flat-trip screwd ...
