Hyundai Sonata: Oil Cooler. Repair procedures - Lubrication System - Engine Mechanical SystemHyundai Sonata: Oil Cooler. Repair procedures

Removal

1.
Loosen the drain plug, and drain the coolant. Remove the radiator cap to speed draining.
2.
Disconnect the oil cooler coolant hoses (A).
3.
Remove the oil filter (A).
4.
Loosen the mounting bolt (A) and remove the oil cooler assembly (B).

Installation

1.
Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler with fix bolt (B).
Tightening torque:
44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

Fix position of oil cooler stopper (A) where oil cooler resists on ladder frame stopper (B).

2.
Apply a light coat of engine oil to the oil filter packing surface (A), and then install the oil filter.
Tightening torque:
11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)
3.
Connect the oil cooler coolant hoses (B).
4.
Fill the radiator with coolant and check for leaks.

    Balance Shaft & Oil Pump. Repair procedures
    Removal 1. Remove the timing chain. (Refer to Timing system in this group) 2. Install a stopper pin (A) after compressing the balance ...

    Oil Pressure Switch. Repair procedures
    Inspection 1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. ...

    See also:

    Trunk Lid. Repair procedures
    Replacement Trunk Lid Assembley Replacement • When removing and installing the trunk lid, an as ...

    Power outlet
    The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 10 amps with the engin ...

    Do not use methanol
    Fuels containing methanol (wood alcohol) should not be used in your vehicle. This type of fuel can reduce vehicle performance and damage components of the fuel system. CAUTION Your New Vehicle L ...