Hyundai Sonata: Rear combination lamp. Repair procedures - Lighting System - Body Electrical SystemHyundai Sonata: Rear combination lamp. Repair procedures

Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear combination lamp cover (A).
3.
Remove the rear combination lamp after loosening the mounting nuts (4EA) and disconnecting the connector (A).
4.
If necessary to remove the bulb, remove the bulb after removing rear combination cover.
[Tail Lamp / Stop Lamp]

[Turn Signal Lamp]

[Tail Lamp]
5.
Remove the trunk lid trim.
(Refer to the BD group - "Trunk")
6.
Remove the trunk lid lamp assembly (A) after loosening the mounting nuts (3EA) and disconnecting the connector.
7.
Replace the bulb after removing the trunk lid lamp assembly.
[Tail Lamp]

[Back Up Lamp]

Installation

1.
Install the trunk lid lamp assembly.
2.
Install the rear combination lamp.

    High Mounted stop lamp. Repair procedures
    Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the rear seat. (Refer to the BD group - "Rear seat") ...

    Troubleshooting
    Troubleshooting 1. The lamp switch inputs can be checked using the GDS. 2. To check the input value of lamp switch, select option "Body Co ...

    See also:

    Air cleaner
    Filter replacement It must be replaced when necessary, and should not be cleaned and reused. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compress ...

    Balance Shaft & Oil Pump. Components and Components Location
    Components 1. Balance shaft & oil pump assembly 2. Balance shaft chain tensioner 3. Balance shaft chain 4. Balance shaft chain sprocket 5. Balance shaft cha ...

    Hazard Lamp Switch. Repair procedures
    Inspection Hazard Lamp Switch 1. Remove the center fascia panel. (Refer to the BD group - "Crash pad") 2. Disconnect the ...