Hyundai Sonata: Repair procedures - Crankcase Emission Control System - Emission Control SystemHyundai Sonata: Repair procedures

Inspection

1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, then put a finger over the open end of the PCV valve and make sure that intake manifold vacuum can be felt.
The plunger inside the PCV valve will move back and forth at vacuum.

4.
If the vacuum is not felt inspect PCV operation, if operating correctly clean or replace the vapor hose.

    Schematic Diagrams
    Schematic Diagram ...

    See also:

    Fuel Pump. Repair procedures
    Removal 1. Release the residual pressure in fuel line (Refer to “Release Residual Pressure in Fuel Line” in this group). 2. Remove th ...

    Front Hub / Knuckle. Components and Components Location - Revised
    Components 1. Split pin 2. Castle nut 3. Brake disc 4. Hub 5. Wheel bearing 6. Snap ring 7. Dust cover 8. Knuckle 9. Drive shaft Compo ...

    Armed stage
    Using the smart key Park the vehicle and stop the engine. Arm the system as described below. 1.Turn off the engine. 2.Make sure that all doors, the engine hood and trunk lid are closed and latched. ...