Hyundai Sonata: Windshield defrosting and defogging
WARNING - Windshield heating
Do not use the or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and that of the windshield could cause the outer surface of the windshield to
fog up, causing loss of visibility. In this case, set the mode selection knob or
button to the
position and fan speed
control knob or button to a lower speed.
- For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed.
- If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position.
- Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows.
- Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.
Climate information screen selection button
To change the screen into the climate information screen, press the climate information
screen selection button. ...
See also:
Window opening and closing
To open or close a window, press down or pull up the front portion of the corresponding
switch to the first detent position (5). ...
Manual transaxle operation
The shift lever can
be moved into any of the forward gears without pulling the ring (1).
The ring (1) must
be pulled while moving the shift lever into reverse.
The manual transaxle has 6 forw ...
Repair procedures
Inspection
Front Door Lock Actuator Inspection
1.
Remove the front door trim.
(Refer to the BD group - "Front door")
2.
R ...