Hyundai Sonata: Fender. Repair procedures - Exterior - Body (Interior and Exterior)Hyundai Sonata: Fender. Repair procedures

Replacement

•
Be careful not to damage the hood and body.
•
Use a clip remover when removing clips.
1.
Remove the front bumper.
(Refer to the BD group - "Front Bumper")
2.
Loosen the mud guard mounting screws.
3.
After loosening the mounting screws and clips, then remove the side sill garnish (A).
4.
After loosening the mounting screw and bolt, then remove the front bumper side mounting bracket (A).
5.
After loosening the fender mounting screw and bolts, then remove the fender (A).
6.
Installation is the reverse of removal.

    Exterior
    ...

    Hood. Repair procedures
    Replacement Hood Assembly Replacement • When removing and installing the hood, an assistant is ...

    See also:

    Interior Trim. Components and Components Location
    Components 1. Front pillar trim 2. Center pillar upper trim 3. Center pillar lower trim 4. Rear pillar trim 5. Cowl side trim 6. Front door scuff trim 7. ...

    Troubleshooting
    Troubleshooting Symption Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Worn crankshaft bearings Lo ...

    Relay Box (Engine Compartment). Description and Operation
    Description Network Configuration The Network of the SJB(Smart Junction Box) consists of Low speed CAN as shown in the following figure. Termination Resistor The SJB has CAN ter ...