Hyundai Sonata: Fuel Tank Air Filter. Repair procedures - Evaporative Emission Control System - Emission Control SystemHyundai Sonata: Fuel Tank Air Filter. Repair procedures

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the canister close valve connector (A).
3.
Disconnect the ventilation tube quick connector (B).
4.
Release the lever (C), and then remove the fuel tank air filter (D) after rotating it in the direction of the arrow in the figure.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
1.
Installation is reverse of removal.

    Fuel Filler Cap. Description and Operation
    Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap an ...

    See also:

    Trunk Lid. Repair procedures
    Replacement Trunk Lid Assembley Replacement • When removing and installing the trunk lid, an as ...

    Stowing the rear seat belt
    The rear seat belt buckles can be stowed in the pocket between the rear seatback and cushion when not in use. ...

    Winter driving
    More severe weather conditions of winter result in greater wear and other problems. To minimize winter driving problem, you should follow these suggestions: Snowy or icy conditions To drive yo ...