Hyundai Sonata: General Information
General
| 1. |
Basically, all measurements in this manual are taken with a tracking
gauge.
|
| 2. |
When a measuring tape is used, check to be sure there is no elongation,
twisting or bending.
|
| 3. |
For measuring dimensions, both projected dimension and actual-measurement
dimension are used in this manual.
|
Measurement Method
| Projected Dimensions |
| 1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
| 2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
| Actual-Measurement Dimensions |
| 1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
| 2. |
Measure by first adjusting both probes to the same length (A=A').
|
| Measurement Point |
| 1. |
Measurements should be taken at the hole center.
|
Body Dimensions
...
Front Body. Body Repair
Front Body A
Front Body B
Front Body C
...
See also:
Auto Light Sensor. Repair procedures
Inspection
In the state of IGN1 ON, when multi function switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto lig ...
ESC OFF Switch. Repair procedures
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the crash pad side switch assembly.
...
Special Service Tools
Special Service Tools
Tools
(Number and Name)
Illustration
Use
09200-38001
Engine support fixture
Removal and in ...



