Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH).

Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.

Side Impact Sensor is also called A-SIS because it detects acceleration.

SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when the collision occurred.

Front Impact Sensor (FIS). Repair procedures

Removal • Removal of the airbag must be performed according to the precautions/ procedures d ...

Side Impact Sensor (SIS). Components and Components Location

Components ...

See also:

Seat belt warning (for driver’s seat)
The driver's seat belt warning light and chime will activate to the following table when the ignition switch is in "ON" position. *1 Warning pattern repeats 11 times with an inter ...

Driver Airbag (DAB) Module and Clock Spring. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag m ...

Rear combination lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear combination lamp cover (A). 3. ...