Hyundai Sonata: Audio Remote Control. Repair procedures - Audio - Body Electrical SystemHyundai Sonata: Audio Remote Control. Repair procedures

Inspection

1.
Check the audio remote control switch for resistance between No.3 and No.5 terminals in each switch position.

Switch
Connector terminal
Resistance (±5%)
Output voltage (±0.22V)
Volume down
3 - 5 (LH)
6.81 kΩ
3.0 V
Volume up
3 - 5 (LH)
4.61 kΩ
2.5 V
Mode
3 - 5 (LH)
2.11 kΩ
1.5 V
Seek down
3 - 5 (LH)
1.11 kΩ
1.0 V
Seek up
3 - 5 (LH)
430 Ω
0.5 V


Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to the RT group)
3.
Remove the steering wheel.
(Refer to the ST group - "Steering column & shaft")
4.
Remove the steering wheel cover (A) after loosening the screws.

5.
Remove the steering wheel remote control switch connector (A) after loosening the mounting screws.


Installation

1.
Reassemble the steering wheel remote control switch after connecting the connector.
2.
Reassemble the steering wheel.
3.
Reassemble the driver airbag module.
Make sure the audio remote control switch and the airbag module connectors are plugged in properly.

    See also:

    Low tire pressure telltale
    When the tire pressure monitoring system warning indicator is illuminated, one or more of your tires is significantly under-inflated. If the telltale illuminates, immediately reduce your speed, a ...

    Components and Components Location
    Component Location 1. Sunroof 2. Sunroof switch 3. Sunroof motor & controller ...

    Rail Pressure Sensor (RPS). Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...