Hyundai Sonata: Climate control air filter - MaintenanceHyundai Sonata: Climate control air filter

Filter inspection

The climate control air filter should be replaced according to the Maintenance Schedule. If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you replace the climate control air filter, replace it performing the following procedure, and be careful to avoid damaging other components.

Filter replacement

Filter replacement

1. Open the glove box and remove the support strap (1).

2. With the glove box open, remove the stoppers by turning them counterclockwise

2. With the glove box open, remove the stoppers by turning them counterclockwise on both sides.

3. Remove the climate control air filter cover while pressing the lock on the

3. Remove the climate control air filter cover while pressing the lock on the right of the cover.

4. Replace the climate control air filter.

4. Replace the climate control air filter.
5. Reassemble in the reverse order of disassembly.

✽ NOTICE

When replacing the climate control air filter install it properly. Otherwise, the system may produce noise and the effectiveness of the filter may be reduced.

    Air cleaner
    Filter replacement It must be replaced when necessary, and should not be cleaned and reused. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compress ...

    Wiper blades
    Blade inspection ✽ NOTICE Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean. Contamination of either the windshield or the ...

    See also:

    Steering Gear box. Components and Components Location
    Components 1. Tie rod end 2. Lock nut 3. Bellows 4. Bellows band 5. Tie rod 6. Rack bar 7. Dust packing 8. Dust cap 9. Oil seal 10. Pinion p ...

    Shift Lever. Repair procedures
    Removal 1. Remove the center console assembly. (Refer to "Interior" in BD group.) 2. Remove the control cable (A). ...

    Turn signals and lane change signals
    The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). Green arrow indicators on the instrument panel indicate which turn ...