Hyundai Sonata: Knock Sensor (KS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Sonata: Knock Sensor (KS). Repair procedures

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold (Refer to “Intake And Exhaust System” in EM group).
3.
Disconnect the injector connector (A).
4.
Remove the installation bolt (B), and then remove the sensor from the cylinder block.

Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

    Heated Oxygen Sensor (HO2S). Description and Operation
    Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

    See also:

    Seat belt precautions
    WARNING All occupants of the vehicle must wear their seat belts at all times. Seat belts and child restraints reduce the risk of serious or fatal injuries for all occupants in the event of a coll ...

    Cowl Top Cover. Repair procedures
    Replacement 1. Remove the covers and remove the nuts, then remove the wiper arm (A). 2. Detach the clips, then remove the cowl top ...

    System controllers and functions
    Audio Head Unit 1. (EJECT) • Ejects the disc. 2. Changes to FM/AM/XM mode. Each time the key is pressed, the mode is changed in order of FM1 ➟ FM2 ➟ AM ➟ XM1  ...