Hyundai Sonata: Alternator. Repair procedures - Charging System - Engine Electrical SystemHyundai Sonata: Alternator. Repair procedures

Removal and Installation

1.
Disconnect the battery negative terminal first, then the positive terminal.
Tightening torque :
(+) terminal : 7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
(-) terminal : 4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove the VIS (Variable intake system) actuator and valve (A).
3.
Disconnect the A/C compressor switch connector (A) the alternator connector (B), and the cable from alternator "B" terminal (C).
4.
Remove the drive belt (A) after turning the drive belt tensioner (B) counterclockwise.
5.
Pull out the through bolt and then remove the alternator (A).
Tightening torque :
49.0 ~ 63.7N.m (5.0 ~ 6.5kgf.m, 36.2 ~ 47.0lb-ft)

6.
Installation is the reverse order of removal.

Disassembly

1.
Remove the alternator cover (A) using a screw driver after loosening the nuts (B).
2.
Loosen the mounting bolts (A) and disconnect the brush holder assembly (B).
3.
Remove the pulley (A) using the SST (09373-27000) (B).
4.
Loosen the 4 through bolts (A).
5.
Disconnect the rotor (A) and cover (B).
6.
Reassembly is the reverse order of disassembly.

Inspection

Inspect Rotor
1.
Check that there is continuity between the slip rings (C).
2.
Check that there is no continuity between the slip rings and the rotor (B) or rotor shaft (A).
3.
If the rotor fails either continuity check, replace the alternator.
Inspect Stator
1.
Check that there is continuity between each pair of leads (A).
2.
Check that there is no continuity between each lead and the coil core.
3.
If the coil fails either continuity check, replace the alternator.

    Alternator. Components and Components Location
    Components 1. Pulley 2. Front bracket 3. Front bearing 4. Bearing cover 5. Bearing cover bolt 6. Rotor 7. Rear bearing 8. Rear bracket 9. Through b ...

    Battery. Description and Operation
    Description 1. The maintenance-free battery is, as the name implies, totally maintenance free and has no removable battery cell caps. 2. W ...

    See also:

    Side impact air bag
    Your vehicle is equipped with a side impact air bag in each front seat. The purpose of the air bag is to provide the vehicle's driver and/or the front passenger with additional protect ...

    Output Speed Sensor. Specifications
    Specification Item Specification Type Hall Effect Sensor,  2pins (Power: 9V, Signal) Operation condition -40 ...

    Fuse/relay panel description
    Inside the fuse/relay panel covers, you can find the fuse/relay label describing fuse/relay name and capacity. Inner panel fuse panel Engine compartment fuse panel ✽ NOTICE Not al ...