Front Cross Member. Repair procedures - Revised

Replacement 1. Remove the front wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

Components and Components Location

Components 1. Sub frame 2. Coil spring 3. Upper arm 4. Assist arm 5. Trailing arm 6. Rear axle ...

See also:

Power Seat Control Switch. Repair procedures
Inspection With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pilla ...

Hazard Lamp Switch. Repair procedures
Inspection Hazard Lamp Switch 1. Remove the center fascia panel. (Refer to the BD group - "Crash pad") 2. Disconnect the ...